[mkiv] Factory oil cooler alternatives

[Kurt Chalopiza]

Thanks Oolan.  You were right, I just called a local hydraulic shop and they do have the 10an Teflon SS braided hose. $7.50 per foot.  They have up to 1 inch diameter.  
   
  

Oolan Zimmer <ozimmer at softhome.net> wrote:
  I use Aeroquip AQP lines, and they hold up OK. Route oil lines far from
the turbo/manifold and you'll be fine.

For all future plumbing, I plan on going with crimped teflon lines. 
Yes, they're available in larger sizes, just not from the race shops. 
Look for the hydraulic shop people with bulldozers, garbage trucks, etc.
use. Also ask the local small nascar teams where they go for plumbing. 
If they don't get big enough, ask at the big truck repair shops and
aircraft hangars. In my central IL location, it's cheaper to have a
shop make me lines than it would be to buy AQP or similar parts from
Summit or Racer Parts Wholesale.

One thing about pro-lite, it's not necessarily more flexible than SS
braided, or if it is you don't want to have it bent that much when
installed. Also, last I checked pro-lite must be crimped so be aware of
tool costs. Ask Earl's what the replacement interval is for pro-lite,
they probably have a recommendation for the teams that use it.

Oolan Zimmer
ozimmer at softhome.net

Kurt Chalopiza wrote:
> Anyone have a recommendation on which hose to go with for the coil cooler? I wanted something with a Teflon lining, but I've only found it up to 8an size. 
> 
> Considering Earl's Pro-Lite 350. Nylon sheath over synthetic rubber rated up to 300* and 350psi. Should be more flexible than the SS braided stuff so easier to install.
> 
> I do many HPDEs in the Texas heat. Will that rubber lined stuff be sufficient?
> 
> Thanks
> 
>
> Oolan Zimmer wrote:
>
> Do you want to remove the old oil cooler or leave it in place as an oil
> warmer? Water heats up faster than oil and the water to oil heat
> exchanger will work in reverse for a time.
>
> Put a spin-on adapter in place of the oil filter and set up a remote oil
> filter. Use -10AN or -12AN lines. If you have an FMIC you can put the
> oil cooler where the old SMIC was on the passenger side. You also need
> to use an oil thermostat so you don't over-cool the oil. Don't forget
> that the oil lines will cool off the oil a little and the oil lines will
> get hot.
>
> I'm partial to Setrab coolers.
>
> 


-- 
Oolan Zimmer
ozimmer at softhome.net

_______________________________________________
Mkiv mailing list
Mkiv at mkiv.com
http://www.mkiv.com/mailman/listinfo/mkiv


       
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile.  Try it now.