[mkiv] Driver door window removal

the_queen_is_dead at cox.net the_queen_is_dead at cox.net
Thu Jan 31 03:57:42 CST 2008


Thanks!  I've got it all taken care of now and I did get some info  
regarding it from another source. The FSM noted those clips and that  
is what confused me.

Just an FYI, there is actually a screw at both ends of that strip and  
I was unable to loosen the one away from the hinge. Luckily I was  
able to get the other one off and the strip lifted right up like you  
said :-)

Thanks again for the input. I appreciate the effort to help.

darrin



On Jan 30, 2008, at 9:51 PM, Supraice wrote:

> darrin
>
> If u r talking about the one on the outside of the door then there  
> is a screw ( better be prepared
> as it is tight like hell by Toyota ) that most be removed first at  
> the end of the door away from the
> hinge side.  It hold the end of the weather stripping.  After you  
> remove the screw you just pull the
> strip upward and it will come... no need to remove the clips as  
> they will come out with the strip.
>
> Ivan
>
>
> -----Original Message-----
> From: mkiv-bounces at mkiv.com [mailto:mkiv-bounces at mkiv.com] On  
> Behalf Of the_queen_is_dead at cox.net
> Sent: Monday, January 21, 2008 7:36 PM
> To: The MKIV.com National Mailing List
> Subject: [mkiv] Driver door window removal
>
> I'm replacing the window regulator as my cable wore and eventually
> snapped. The window and everything is buried deep down inside the
> door and I'm following the FSM to remove everything to get it out.
> I've run into a slight problem....
>
> I can't figure out how to remove the weather stripping at the top of
> the door (the piece that "rubs" against the window as it goes up and
> down) so as to create enough clearance to get the glass and the
> attached parts out. The FSM states there are 6 clips at the top of
> the door that need to come off to release it. I can see them (they
> are white). I just can't figure out how to get them off. I'm afraid
> I'll break them and would appreciate any info/tips to finish this
> job. Most importantly..
>
> How do i remove those white clips without snapping them?
>
> Thanks!
> darrin
> 95 TT 6-spd.
>
>
> p.s. is it absolutely necessary to remove the outside door handle as
> indicated?
> _______________________________________________
> Mkiv mailing list
> Mkiv at mkiv.com
> http://www.mkiv.com/mailman/listinfo/mkiv
>
> _______________________________________________
> Mkiv mailing list
> Mkiv at mkiv.com
> http://www.mkiv.com/mailman/listinfo/mkiv



More information about the Mkiv mailing list